Technical Support Notes
| Article ID: | T1087 |
| Date: | 10/7/02 |
| Product: | EPSON RC+ v3.4.1, v3.5.0 |
| Subject: | Comm port not found error during SETVER |
Symptoms
If a comm port is disabled and you execute SETVER from a
MKVER that had the comm port enabled, you will see a message box stating that
the comm port was not found. The comm port works anyway.
Causes
This is caused by a bug in EPSON RC+.
Remedy
This error can be ignored. To avoid
the error, you can enable the comm port(s) before you execute
SETVER.
Status
This problem
will be fixed in a future release.
